#Jack hammer golf club how to#
#Jack hammer golf club install#

Once youвЂ™re able to get the clip off, the axle will slide easily from its place. You will have to put the pliers through one of them and look through the hole to check if youвЂ™re able to gain access to the clip. This C-clip or retainer nut can be accessed only using a pair of 90-degree C-clip pliers. This is often a C-clip and keeps the axle in position inside the tube. The axle bearing of a 1998 electric Club Car rear axle houses a retainer nut that is located inside the axle tube. This is often helpful when the axle is installed. If the groove that houses the ring is damaged with a burr on the edges, you can use the edge of a small three-sided file to knock off the burr. Pliers with an offset angle or Snap-on pliers can also be used. If you donвЂ™t have a pair of 90-degree pliers, you should ensure that the snap ring pliers that you use are of the right size at the tips. Alternatively, you can consider wearing a minerвЂ™s light. The flashlight will help you see the ring clearly through the holes.

Put the 90-degree snap ring pliers through the holes in the hub and pull at the snap ring till it comes off.

Take off the rear wheel from the Club Car golf cart.

You can remove the rear axle snap ring on a Club Car using a pair of 90-degree snap ring pliers and a flashlight.

#Jack hammer golf club how to#

How to remove the rear axle snap ring of a Club Car ItвЂ™s often advisable to remove both the axle seals at the same time and replace them at the same time. The slide hammer can also be used to remove the axle adapter ring and seal. How to remove the rear bearing from the axle

#Jack hammer golf club install#

If you want to install a new axle assembly, youвЂ™ll have to do the above steps followed by fitting the new assembly in place and redoing these steps once again in the reverse order. In a 2002 Club Car DS, you can remove the rear axle seal from the axle opening by popping it out using a seal puller.

Take off the clamp spring or C-clip from the axle assembly using the internal retaining ring pliers or 90-degree C-Clip pliers.

This is done as a precautionary measure in case the jack slips down accidentally.

Take off the rear wheel and place it below the chassis of the golf cart near the jack.

Take off the screws fitted on the rear wheel using the same socket mentioned above.

Lift the rear suspension frame using the floor jack so that the rear wheel is suspended in the air.

Loosen the screw from the wheels using the 3/4-inch or 19mm socket.

Take off the wheel cover from the rear wheel using the slotted screwdriver.

Block the front wheels of the cart so that it doesnвЂ™t start moving unexpectedly.

Press the park brake pad of the golf cart down as much as possible.

The following steps can help you to remove the rear axle from your Club Car DS.

Internal retaining ring pliers or 90-degree C-Clip pliers.

You will need the following tools to remove the rear axle from a Club Car DS. Taking off the brake shoes and other such components also do not offer much clearance. However, itвЂ™s worth bearing in mind that there is usually limited space to insert a 90-degree spring clip pliers in the gap between the clip and the rear of the axle flange. You can remove the rear axle on a Club Car Precedent by carrying out the steps mentioned above. Taking this clip off from its place can help you remove the axle from the Club Car. This clip is often inside the axle tube behind the drum mounting flange. You can also check for a C-clip at the backside of the golf cart that keeps the axle in position. You may require a slide hammer to help you with releasing the bearing from the axle if itвЂ™s stuck on to it.

Insert a 90-degree snap ring pliers through the holes in the hub and remove the snap ring.

Take off the brake drum from its place.

Remove the rear wheel of the golf cart.

How to Remove the rear axle on a Club Car Precedent: You can remove the rear axle of a Club Car golf cart by taking off the snap ring that is located behind the hub. How do I remove the rear axle on a Club Car golf cart?

How to remove the axle shaft on Club Car DS.

How to remove rear axle of a 1987 Club Car.

1998 electric Club Car rear axle removal.

How to remove the rear axle snap ring of a Club Car.

How to remove the rear bearing from the axle.

How do I remove the rear axle on a Club Car golf cart?.